![]() ![]() Install a 3A fused jumper wire between the control circuit terminal A and the low reference circuit terminal B. If the circuit tests normal, replace the ECM. If not the specified value, test the control circuit for a short to ground. Verify the scan tool CMP Sol Ckt Short Gnd Test status is OK.ĥ. If the circuit tests normal, replace the ECM.Ĥ. If the test lamp illuminates, test the control circuit for short to voltage. Verify that a test lamp does not illuminate between the low reference circuit terminal B and the control circuit terminal A.ģ. If greater than the specified range, test the low reference circuit for an open/high resistance. Test for less than 5 ohms between the low reference circuit terminal B and ground. Ignition OFF, disconnect the CMP actuator solenoid harness connector at the CMP actuator solenoid.Ģ. The difference is present for more than 13.5-seconds Diagnose P0013 and P0014ġ.The desired camshaft angle versus actual camshaft angle is more than 6°.The desired versus actual camshaft position is no greater than 25° or less than 5°.The PCM has commanded the Camshaft Position. ![]() To set the P0011 or P0014 trouble code, the PCM must see:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |